Henan Wanda Industrial Intelligent Equipment Co., Ltd

NEWS

——

Company News

Industry News

How to adjust the track of nano sand mill

Time

2023-10-18

Source

Author

How should the track of nano sand mill be adjusted? And what are the precautions? Below, the answer is for you.

Crawler tension can be adjusted at one end of the square shaft, when adjusting, use the bucket to dig a pit with a depth of 0.5m in front of the crawler, then drive the electric shovel forward, so that the crawler under the light wheel is off the ground, remove the bracket, throw the strength of the appropriate steel wire rope bolted between the square shaft and the bucket tooth tip, using the action of raising and pushing to tighten the crawler. You can also use the jack to tighten the square shaft. When the square shaft moves away from the required travel and makes the track reach the regular tension degree, join the corresponding number of shims in the gap between the square shaft and the track frame.

Care should be taken that the total thickness of the shims on both track frames is as equal as possible. Then remove the wire rope. And settle the bracket in the original place. The adjusted tightness of the nano sand mill track specification should be: so that the track is pressed on the pallet, and no slack can be seen between the wheel and the wheel. Linear vibrating screen in the adjustment of walking tracks, should also pay attention to the following points; each side of the drive wheel, bracket dry, light wheel radial symmetry surface must be in the same straight surface, the difference between each other is not more than 5mm.

Any two connected track plates of the nano-sander should ensure that they can be freely turned around the pin. Adjustment of traveling holding brake The traveling bubble gate of the electric shovel is installed between the motor and the traveling reduction box; its purpose is to brake the traveling mechanism. Especially when the electric shovel is excavating. Can make the electric shovel firmly stopped in the corresponding position, or in the ramp traveling sudden power failure, can make the walking mechanism agile braking, not to attack the phenomenon of slippery slope.

Recent News

■

The crushing principle of nano sand mill

—

2023-06-12